Marketplace logo

Vendor

Cisco

Product

IOS

Project Type

Workflow Project


View Repository
Workflow

Cisco IOS Upgrade

Overview

This pre-built contains the Cisco IOS device upgrade workflow for NSO and Ansible using IAP. The workflow requires that a newer binary version file is already downloaded locally on the destination device (bootflash:), and file integrity has been verified (using md5). To satisfy these pre-requirements, use the free file-transfer pre-built available from Itential.

This solution consist of the following:

  • Main Workflow (IAP-Artifacts IOS Device Upgrade)

    • Perform device environmental checks. Verifies a device is on a different version than the requested one.
    • Perform pre-checks to confirm device readiness.
    • Backup the running-config locally on flash drive.
    • Perform boot statement configuration to direct the router to load the newer version upon the next boot.
    • Issue the reload command.
    • Wait for device to become available after reboot.
    • Confirm reliable connectivity (ping consistency).
    • Perform post-checks to verify the device functionality running the new version.
    • Show a Pre-Post Checks diff report.
    • Perform MOP analysis to verify no unexpected config changes occurred.
    • Show a MOP analysis report.
    • Perform rollback, if requested.
  • Command Templates

    • Will run the pre / post commands and evaluate them against set thresholds.
  • Analytic Templates

    • Will run the pre vs. post comparisons and evaluate them against set thresholds.
  • Automation Catalog Entry with a JSON-Form:

    • Mode selection: Zero-Touch, Normal, or Verbose
    • Allows user to pick destination device to run the upgrade on.
    • Allows user to pick software version to upgrade to (file names are hard coded in JSON form).
    • Ping-consistency variables

How to Install

To install the pre-build:

  • Verify you are running a supported version of the Itential Automation Platform (IAP) as listed above in the Prerequisites section.
  • The pre-build can be installed from within App-Admin_Essential. Simply search for the name of your desired pre-build and click the install button.